5. パス

Paths are curves (known as Bézier-curves). Paths are easy to learn and use in GIMP. To understand their concepts and mechanism, look at the glossary Bézier-curve or Wikipedia [WKPD-BEZIER]. The Paths tool is very powerful, allowing you to design complex shapes. When designing a shape, you first use the Paths tool in GIMP to create a path. After that you usually stroke or fill the path.

GIMP の用語法では、 パスの境界線を描画するとはパスに色、 幅、 パターンなどの具体的な姿を与えることを意味します。

A path can be used in several ways:

図7.10 Illustration of four different paths

Illustration of four different paths

GIMP パスの 4 例: 閉じた多辺形、 開いた多辺形、 閉じた曲線、 直線と曲線の混成。


5.1. パスの作成

パスははじめのうちは大まかな線でかまいません。 後からでも変形ができます。 (その方法は パス ツールのところで述べています。) まずは次のいずれかの方法でパスツールを呼び出してください。

  • Use ToolsPaths from the menu.

  • ツールボックスのツールアイコン

  • キーボードショートカット B

When the Paths tool is selected, the mouse cursor changes into a crosshair with a curve by default. The actual shape depends on your mouse pointer mode setting. Make sure that the Paths Edit Mode in Tool Options is set to Design.

Left click in the image to create the first point of the path. Move the mouse to a new point and left click to create another point linked to the previous point. Although you can create as many points as you desire, you only need two points to learn about Paths.

While adding points, the mouse cursor has a little + next to the curve, which indicates that clicking will add a new point.

When the mouse cursor is close to one of the path points, the + changes into a cross with arrows; like the move tool. You can then move the existing path point.

To close your path, go with the mouse on top of the point you want to connect to, and then Ctrl-click that point. When you are done designing your path, you can click Enter. This will turn the path into a Selection. You can also keep adding more points, or start changing the curves of the path.

To edit the curves of your path, move the mouse cursor close to a line segment, left-click and drag the line segment. Two events occur.

  • 線分はつかんで引くにしたがって曲折します。

  • Each line segment has two start points and end points marked by little square rectangles, these are called handles. A direction line now projects from each start point for the line segment that was moved. This direction line usually has a different color than the lines of the path.

The curved line segment leaves an end point in the same direction that the direction line leaves the start point. The length of this line controls how far the line segment projects along the direction line before curving towards the other path point.

The handle at the end of each direction line can be dragged to change the direction and length of the curve. The handles on the other end, where they connect to the path, can be used to move the position of that path point.

図7.11 操作中のパスの様子

操作中のパスの様子

Appearance of a path while it is manipulated using the Paths tool.


図のパスには直線や曲線の入り交じった 2 本の成分があります。 黒い正方形はアンカーポイントを、 ひとつだけある白丸は選択されたアンカーを表していて、 2 つの白い正方形はそのアンカーから延びる 2 本の曲線のハンドルを表しています。